HPE ProLiant DL385 Gen10 Plus v2 Maintenance And Service Manual page 129

1
For Networking Choice server models, the embedded NIC ports are not equipped on the server. Therefore, the NIC LEDs on the
Systems Insight Display will flash based on the FlexibleLOM network port activity. In the case of a dual‑port FlexibleLOM, only NIC
LED 1 and 2 will illuminate to correspond with the activity of the respective network ports.
When the health LED on the front panel illuminates either amber or red, the server is experiencing a health event. For more information
on the combination of these LEDs, see Systems Insight Display combined LED descriptions .
Systems Insight Display combined LED descriptions Systems Insight Display combined LED descriptions
The combined illumination of the following LEDs indicates a system condition:
Systems Insight Display LEDs
System power LED
Health LED
Systems Insight Display Systems Insight Display
LED and color LED and color
Processor (amber)
Processor (amber)
DIMM (amber)
DIMM (amber)
Over temp (amber)
Over temp (amber)
PCI riser (amber)
Fan (amber)
Fan (amber)
Power supply (amber)
Health Health System System Status Status
LED LED power LED power LED
Red Amber One or more of the following
conditions might exist:
Amber Green Processor in socket X is in a pre-
failure condition.
Red Green One or more DIMMs have failed.
Amber Green DIMM in slot X is in a pre-failure
condition.
Amber Green The Health Driver has detected a
cautionary temperature level.
Red Amber The server has detected a hardware
critical temperature level.
Red Green The PCI riser cage is not seated
properly.
Amber Green One fan has failed or has been
removed.
Red Green Two or more fans have failed or
been removed.
Red Amber One or more of the following
conditions might exist:
HPE ProLiant DL385 Gen10 Plus v2 Server Maintenance and Service Guide
Processor in socket X has failed.
Processor X is not installed in
the socket.
Processor X is unsupported.
ROM detects a failed processor
during POST.
Only one power supply is
installed and that power supply
is in standby.
Power supply fault.
System board fault.
129