HPE ProLiant DL385 Gen10 Plus v2 Maintenance And Service Manual page 65

Removing and replacing the PCIe riser board Removing and replacing the PCIe riser board
Prerequisites Prerequisites
Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
Procedure Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
Extend the server from the rack .
Remove the server from the rack .
4. Remove the access panel .
5. Release the full-length expansion board retainer if necessary .
6. Remove the PCIe riser cage:
Remove the primary PCIe riser cages
Remove the secondary and tertiary PCIe riser cage
7. Remove any expansion boards from the PCIe riser cage.
8. Remove the PCIe riser board:
Primary and secondary riser cage
Tertiary riser cage
HPE ProLiant DL385 Gen10 Plus v2 Server Maintenance and Service Guide 65