HPE ProLiant DL385 Gen10 Plus v2 Maintenance And Service Manual page 80

To replace the component, reverse the removal procedure.
Removing and replacing the NVMe drive backplane Removing and replacing the NVMe drive backplane
Prerequisites Prerequisites
Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
Procedure Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
Extend the server from the rack .
Remove the server from the rack .
4. Remove the access panel .
5. Remove the LFF midplane cage .
6. Remove the NVMe drive backplane.
HPE ProLiant DL385 Gen10 Plus v2 Server Maintenance and Service Guide 80