HPE ProLiant DL385 Gen10 Plus v2 Maintenance And Service Manual page 93

Remove the midplane drive cage .
6. Remove the fan cage.
7. Disconnect the energy pack cable, and then remove the energy pack.
To replace the component, reverse the removal procedure.
Removing and replacing a Smart Array type-a modular controller Removing and replacing a Smart Array type-a modular controller
Procedure Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
Extend the server from the rack .
Remove the server from the rack .
4. Remove the access panel .
5. Do one of the following:
Remove the air baffle .
Remove the midplane drive cage .
6. Disconnect the SAS cables.
7. Remove the modular controller.
HPE ProLiant DL385 Gen10 Plus v2 Server Maintenance and Service Guide 93