HPE ProLiant DL385 Gen10 Plus v2 Maintenance And Service Manual page 45

2. If necessary, use a T-25 Torx screwdriver to loosen the shipping screws.
3. Extend the server from the rack.
4. After performing the installation or maintenance procedure, slide the server back into the rack, and then press the server firmly into
the rack to secure it in place.
WARNING: WARNING:
To reduce the risk of personal injury, be careful when pressing the server rail-release latches and sliding the server
into the rack. The sliding rails could pinch your fingers.
Remove the server from the rack Remove the server from the rack
To remove the server from a Hewlett Packard Enterprise, Compaq-branded, Telco, or third-party rack, complete the following.
Procedure Procedure
1. Power down the server .
2. Extend the server from the rack .
3. Disconnect the cabling and remove the server from the rack.
For more information, see the documentation that ships with the rack mounting option.
4. Place the server on a sturdy, level surface.
Remove the access panel Remove the access panel
WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives, power supplies, and internal system WARNING:
components to cool before touching them.
HPE ProLiant DL385 Gen10 Plus v2 Server Maintenance and Service Guide 45