HPE ProLiant DL385 Gen10 Plus v2 Maintenance And Service Manual page 85

To identify the DIMMs installed in the server, see DIMM slot locations.
Procedure Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
Extend the server from the rack .
Remove the server from the rack .
4. Remove the access panel .
5. Do one of the following:
Remove the air baffle .
Remove the midplane drive cage .
6. Remove the DIMM.
To replace the component, reverse the removal procedure.
For DIMM configuration information, see the server user guide.
Removing and replacing a heatsink Removing and replacing a heatsink
This procedure shows a standard heatsink as an example. The replacement process is the same for both the standard and high-
performance heatsinks.
Hewlett Packard Enterprise recommends identifying the processor and socket components before performing this procedure.
Prerequisites Prerequisites
HPE ProLiant DL385 Gen10 Plus v2 Server Maintenance and Service Guide 85