HPE ProLiant DL385 Gen10 Plus v2 Maintenance And Service Manual page 70

4. Remove the access panel .
5. Remove all drives .
6. Remove the fan cage.
7. Disconnect all cables from the universal media bay.
8. Remove the universal media bay.
To replace the component, reverse the removal procedure.
Removing and replacing the LFF power switch module Removing and replacing the LFF power switch module
Prerequisites Prerequisites
Before you perform this procedure, make sure that you have a T-10 Torx screwdriver available.
Procedure Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
Extend the server from the rack .
Remove the server from the rack .
4. Remove the access panel .
5. Remove all drives .
6. Remove the fan cage.
7. Disconnect all cables connecting the power switch module to the system board and other components.
HPE ProLiant DL385 Gen10 Plus v2 Server Maintenance and Service Guide 70