GRAPHTEC midi LOGGER HV User Manual page 112

CHAPTER 3 Settings and Measurement
(1)-11 Misc .
< Pulse >
Setting
(1) Annotation Settings
(2) Span Settings
(3) Set waveform color
(4) Line Thickness Setting
(5) Trace
(6) Pulses per revolution
(7) Integration clear (all CH)
3-68
< Logic >
(1)
(2)
(3)
(4)
(5)
(6)
(7)
Set the annotation (comment) displayed in the CH.
Set the upper and lower limits of the span displayed in the Y-T waveform. (Pulse only)
* When Pulse input is Integration, it is in the auto span state and can not be set.
Set the display color of each CH. 0 to 31 for each of red, green, blue (RGB)
Set the line thickness (1 to 8 dots). (Pulse only)
Set the waveform display to On or Off.
1 to 10000
When the pulse input is set to Pulses per revolution, set the number of pulses per revolution.
The number of revolutions per minute (RPM) is calculated, assuming that the number of
pulses set here is one revolution. When 100 is set, and then 100 pulses are input, it is 1
revolution when 100 pulses have been input.
<Calculation formula>
Number of revolutions (RPM) = Number of pulses ÷ Number of pulses per revolution x 60
(1 minute)
<Example>
Number of pulses per revolution: 100 (1 rotation is judged when 100 pulses have been
input.)
Pulse input: 1000 Hz (1000 pulses per sec.)
Number of revolutions: 600 RPM (600 RPM per min.)
Clear (set to 0) the integrated value of the pulse CH that is set to the Integration input. (Pulse
only)
(1)
(3)
(5)
Description