Connecting The Power Cable And Turning The Power On - GRAPHTEC midi LOGGER HV User Manual

2 .6 Connecting the Power Cable and Turning the Power on

This section describes how to connect the power cable and turn the power on. The connection method will
vary depending on the type of power supply used.
Connecting to an AC Power Supply
Use the AC cable and AC adapter that are provided as accessories.
Be sure to use the AC adapter that is supplied as a standard accessory .
(1) Plug the AC cable into the AC adapter.
(2) Connect the output side of the AC adapter to the connector on this device.
(3) Using the flat-blade screwdriver, press against the minus (-) button above the GND terminal, while
connecting the grounding cable to this device connect the other end of the cable to ground.
(4) Plug the AC cable into the main power outlet.
(5) Press the power switch to the ON position to start.
Always connect the GND terminal and refer to the TO ENSURE SAFE AND CORRECT USE precautions .
This device must be grounded even when connected to other devices and sharing a common ground level .
AC adapter
AC cable
AC adapter cable
CHAPTER 2 Checks and Preparation
2-7