Quit - H3C S6550X-HI Series Command Reference Manual

Views
System view
Predefined user roles
network-admin
Parameters
: Specifies a hotkey. To display the supported hotkeys, enter
hotkey
: Specifies the command to be assigned to the hotkey.
command
function function
supported functions, enter
: Removes the command or function assignment for the hotkey. After you remove the
none
assignment for a hotkey, pressing the hotkey does not execute any command or function.
Usage guidelines
The device supports a set of hotkeys. Pressing a hotkey executes the command or function assigned
to the hotkey. You can configure all the hotkeys except Ctrl+].
A hotkey can correspond to only one command or function. If you assign multiple commands or
functions to the same hotkey, the most recently assigned command or function takes effect.
A command or function can be assigned to multiple hotkeys. You can use any of those hotkeys to
execute the command or function.
If a hotkey is also defined by the terminal software you are using to interact with the device, the
terminal software definition takes effect.
Examples
# Assign move_the_cursor_to_the_beginning_of_the_line function to hotkey Ctrl+U.
<Sysname> system-view
[Sysname] hotkey ctrl_u function move_the_cursor_to_the_beginning_of_the_line
# Disable the configurable command or function assigned to hotkey Ctrl+A.
<Sysname> system-view
[Sysname] hotkey ctrl_a none
Related commands
display hotkey

quit

Use to return to the upper-level view.
quit
Syntax
quit
Views
Any view
Predefined user roles
network-admin
network-operator
Usage guidelines
Executing this command in user view disconnects you from the device.
: Specifies the function to be assigned to the hotkey. To display the
hotkey hotkey function ?
11
or see
hotkey ?
or see Table 3.
Table 3.