Current Measurement At Dpm Low Power Mode; Figure 62: Current Measurement At Dpm Low Power Mode - Renesas FreeRTOS DA16200 User Manual

UM-WI-056
DA16200 DA16600 FreeRTOS Getting Started Guide
For instance, [/DA16200/SYS.HAL] # sleep 3 10
It will make DA16200 stay at sleep 3 f or a set amount of time (10 seconds) and wake up .
6.5.6

Current Measurement at DPM Low Power Mode

●
Enable DPM mode as described in Section
○
When running the DA16200 with DPM settings, DA16200 will run sleep 3 state and wake
up for Beacon check and Keep Alive according to the conf igured DTIM
For example: Figure 62 shows the current wavef orm with settings DTIM 10 (about 1sec @ AP
DTIM=1) and Keep Alive 30s. Sleep 3 means sleep state in the interval between RXs or between RX
and TX.

Figure 62: Current Measurement at DPM Low Power Mode

User Manual
CFR0012
6.4.2
Revision 1.8
72 of 106
Aug. 18, 2023
© 2023 Renesas Electronics