Configuration For Testing At Command With Evb Only; Figure 9: Da16200 Evb Configuration For At-Cmd Over Uart To Ft2232H; Table 9: Default Gpio Pin Settings Of Uart And Spi; Table 10: Da16200 Evb Switch Configuration For At-Cmd Over Uart Of Ft2232H - Renesas FreeRTOS DA16200 User Manual

UM-WI-056
DA16200 DA16600 FreeRTOS Getting Started Guide
Table 9 shows the def ault GPIO pin settings of the UART and SPI interf aces of the DA16200 SDK
and DA16600 SDK. These GPIOs need to be connected to the MCU.

Table 9: Default GPIO Pin Settings of UART and SPI

Interface
UART
SPI
MCU Wake-up on AT-CMD
4.7.1

Configuration for Testing AT Command with EVB Only

Both the DA16200 and DA16600 EVBs include an FT2232H which is used to test AT Command over
the UART interf ace. Figure 9
Command processing over the UART. This conf iguration connects UART1 of the DA16200
(GPIOA4/5) to the FT2232H.

Figure 9: DA16200 EVB Configuration for AT-CMD over UART to FT2232H

Table 10: DA16200 EVB Switch Configuration for AT-CMD over UART of FT2232H

SW1 SW2
All OFF All ON
Figure 10 and Table 11 show how to conf igure the DA16600 EVB f or AT Command processing over
the UART. This conf iguration connects UART2 of the DA16200 (GPIOC6/7) to the FT2232H.
User Manual
CFR0012
DA16200 SDK
GPIOA4 (UART1_TXD)
GPIOA5 (UART1_RXD)
GPIOA2 (SPI_CSB)
GPIOA3 (SPI_CLK)
GPIOA8 (SPI_MISO)
GPIOA9 (SPI_MOSI)
GPIOC6 (INT)
GPIOA11 (MCU Wake-up)
and Table 10 shows how to conf igure the DA16200 EVB f or AT
SW3 SW4
All OFF All ON
Revision 1.8
30 of 106
DA16600 SDK
GPIOC6 (UART2_TXD)
GPIOC7 (UART2_RXD)
SW7 SW8
All ON LEFT
SW9 SW10
LEFT All ON
Aug. 18, 2023
© 2023 Renesas Electronics