UM-WI-056
DA16200 DA16600 FreeRTOS Getting Started Guide
4.3
DA16600 EVB Ver 6.0
Figure 2
shows the hardware configuration of the DA16600 EVB.
DA16600 EVB has the f ollowing components:
Table 3: Components on DA16600 EVB
No
Name
SW3 – GPIO selective Switch
1
SW4 – GPIO selective Switch
2
SW5 – GPIO selective Switch
3
SW6 – GPIO selective Switch
4
SW7 – GPIO selective Switch
5
6
Board information
CN6 – USB Port (BLE)
7
CN1 – USB Port (Wi-Fi)
8
P77 – GND Pins
9
SW2 – RTC Wake up2 key
10
SW1 – RTC Power key
11
SW10 – Switch to control the
12
SPDT
J7 & CN7 – JTAG Connector
13
User Manual
CFR0012
Figure 2: DA16600 EVB Hardware Configuration
GPIO selection switch, default ON, see
GPIO selection switch, default OFF, see
GPIO selection switch, default ON, see
GPIO selection switch, default OFF, see
GPIO selection switch, default OFF, see
Board version and manufacturing date
Connect directly to DA14531 for debug only.
Note: Do not use this port during normal operation.
Provides UART0 for debug and UART1 for test.
GND for test
Switch to wake up the board from sleep mode.
Switch to turn the EVB on and off.
Switch to control RF switch in DA16600MOD at test mode, default OFF.
Connector for IARs I-jet JTAG Debugger.
Revision 1.8
12 of 106
Description
Table
4.
Table
4.
Table
4.
Table
4.
Table
4.
Aug. 18, 2023
© 2023 Renesas Electronics