Table 19: Gpio And Spi Selection Switch - Renesas FreeRTOS DA16200 User Manual

UM-WI-056
DA16200 DA16600 FreeRTOS Getting Started Guide
No Name
P2 – Jumper to measure
10
current consumption of the
DA16200
SW1 – GPIO selection switch
11
SW2 – GPIO selection switch
12
SW3 – GPIO selection switch
13
SW4 – GPIO selection switch
14
SW7 – UART0 selection switch
15
J3, J4 – External Connector
16

Table 19: GPIO and SPI Selection Switch

Switch Pin Relevant
GPIO
SW1 1 GPIOA6
2 GPIOA7
3 GPIOA8
4 GPIOA9
SW2 1 GPIOA4
2 GPIOA5
SW3 1 GPIOA0
2 GPIOA1
3 GPIOA2
4 GPIOA3
SW4 1 GPIOA6
2 GPIOA7
SW7 1 UART0_TXD
2 UART0_RXD
The current consumption can be measured at jumper P2 with current measuring equipment. See
Section 6.5 f or details on the test setup.
When DA16200 EVK Pro Board is used f or measuring current consumption, the P1 jumper must be
removed.
For more details on the DA16200 EVB, see the schematic Ref . [9].
User Manual
CFR0012
Pin for current measurement.
For normal operation, this pin should be shorted.
- Pull out the Short Pin cap and use jumper wires to
connect to the measuring equipment.
GPIO selection switch, default OFF, see
GPIO selection switch, default ON, see
GPIO selection switch, default ON, see
GPIO selection switch, default ON, see
UART0 selection switch, default ON, see
Provides access to all pins of the DA16200MOD for testing and
debugging.
On
Connects FT2232H to SPI_CSB
Connects FT2232H to SPI_CLK
Connects FT2232H to SPI_MISO
Connects FT2232H to SPI_MOSI
Connects FT2232H to UART1_TXD
Connects FT2232H to UART1_RXD
Connects FT2232H to SPI_CSB
Connects FT2232H to SPI_CLK
Connects FT2232H to SPI_MISO
Connects FT2232H to SPI_MOSI
WPS
Factory Reset
Connects FT232H to UART0_TXD
Connects FT232H to UART0_RXD
Revision 1.8
77 of 106
Description
Table 19.
Table 19.
Table 19.
Table 19.
Table 19.
Off
WPS
Factory Reset
Ext Con (J3/J4) only
Ext Con (J3/J4) only
Ext Con (J3/J4) only
Ext Con (J3/J4) only
Ext Con (J3/J4) only
Ext Con (J3/J4) only
Ext Con (J3/J4) only
Ext Con (J3/J4) only
Ext Con (J3/J4) only
Ext Con (J3/J4) only
NC
NC
Aug. 18, 2023
© 2023 Renesas Electronics