Table 23: Description Of Switches - Renesas FreeRTOS DA16200 User Manual

UM-WI-056
DA16200 DA16600 FreeRTOS Getting Started Guide
ID Name
10 Connector CN4
11 Switch SW3
12 Switch SW7
S2 – Factory Reset
13
Button
S1 – WPS Button
14
S3 – DA14351 Reset
15
Button
16 Connector J2
17 Connector J14
18 Switch SW4
19 Switch SW5
DA16600MOD EVB includes several switches, see description f or each switch below.

Table 23: Description of Switches

Switch Pin
SW7 1 Connects WPS button S1 to GPIOA6
2 Connects Factory Reset button S2 to GPIOA7
Enables Keil toolchain debug of DA14531
3
(SWCLK)
4 Enables Keil toolchain debug of DA14531
(SWDIO)
5 Enables UART debug of DA14531 (UART2 RX)
6 Enables UART debug of DA14531 (UART2 TX)
7 Does not use
8 Does not use
User Manual
CFR0012
GPIO test connector.
Add jumpers from J2/J4 to CN4 to control the four LEDs using GPIOs.
Switch to connect directly to DA14531 and use UART to check
®
Bluetooth LE performance.
Set this switch to off for normal operation.
Multipurpose switch.
Set this switch to off for normal operation.
Factory reset button of DA16200 using GPIO_7.
To enable this button, set Pin 2 of SW7 to on.
WPS button of DA16200 using GPIO_6.
To enable this button, set Pin 1 of SW7 to on.
Reset button of DA14531 in test mode.
GPIO connector.
GPIO connector.
Switch to control RF switch in DA16600MOD at test mode.
Switch to check current consumption using a power meter kit.
Description
Revision 1.8
82 of 106
Description
Relevant pin
DA16200 GPIOA6
DA16200 GPIOA7
DA14531 P0_2/SWCLK
DA14531 P0_10/SWDIO
DA14531 P0_8/DEBUG
DA14531 P0_9/DEBUG
- -
- -
© 2023 Renesas Electronics
Default
ON
ON
OFF
OFF
OFF
OFF
OFF
OFF
Aug. 18, 2023