Table of Contents
Advertisement
UM-WI-056
DA16200 DA16600 FreeRTOS Getting Started Guide
2. Use the command netsh interface show interface to f ind the interf ace name.
C:\user\testuser>netsh interface show interface
Admin State
State
-------------------------------------------------------------------------
Enabled
Connected
Enabled
Disconnected
3. Use the interf ace name f ound f or DA16200 to set the ARP cache to static with the netsh
command and then use arp -a to verif y that it is now a static ARP entry.
C:\user\testuser>netsh interface ip add neighbors "Ethernet" "192.168.0.66" "d4-3d-39-10-a2-48"
C:\WINDOWS\system32>arp -a
Interface: 192.168.0.105 --- 0x12
Internet Address
192.168.0.1
192.168.0.66
192.168.0.255
224.0.0.2
224.0.0.22
224.0.0.251
239.255.255.250
255.255.255.255
The DA16200's IP address 192.168.0.66 is now added to ARP table as a static type.
4. Use the command arp -d or netsh interface ip delete arpcache to initialize the ARP cache.
6.3
Throughput Test
This section describes how to perf orm the throughput test using the TCP client/server protocol.
DA16200 has a command iperf f or measuring throughput perf ormance. To do the throughput test,
prepare the DA16200 to operate in Station Mode as described in Section
described in Section 6.4.3.
6.3.1
Test Setup
The Iperf tool should be installed on your laptop. Iperf Version 2.0.9 is recommended.
NOTE
Iperf 3.x is not supported.
To setup Iperf tool, f ollow the steps below:
1. Download Iperf f rom
2. Create a f older called Iperf in path C:\.
User Manual
CFR0012
Type
Interface Name
Dedicated
Ethernet
Dedicated
Wi-Fi
Physical Address
Type
80-ca-4b-30-02-09
dynamic
d4-3d-39-10-a2-48
static
ff-ff-ff-ff-ff-ff
static
01-00-5e-00-00-02
static
01-00-5e-00-00-16
static
01-00-5e-00-00-fb
static
01-00-5e-7f-ff-fa
static
ff-ff-ff-ff-ff-ff
static
Figure 46: Throughput Test Environment
https://iperf
.fr/iperf-download.php.
Revision 1.8
58 of 106
4.6.1
and disable DPM as
Aug. 18, 2023
© 2023 Renesas Electronics
Advertisement
Table of Contents
