Figure 50: Setup Da16200 Evb Jumper; Figure 51: Current Test Environment With Evk Pro For Da16600; Figure 52: Setup Da16600 Evb Jumper - Renesas FreeRTOS DA16200 User Manual

UM-WI-056
DA16200 DA16600 FreeRTOS Getting Started Guide
Figure 51 shows a typical test setup environment with DA16600 EVK PRO board and Wi-Fi IoT
Power Prof iler Tool.

Figure 51: Current Test Environment with EVK PRO for DA16600

1. To measure current with DA16600 EVK PRO board, connect the two boards with the PCI
connector.
2. Change the jumper setting (P1 and P2) and switch (SW5) settings on the DA16600 EVB.
3. Open the DA16600 EVB's power two jumper caps as shown in
There is a selectable DIP Switch (SW5):
○
If SW (1) moves to switch on, measure the current of Wi-Fi chipset
○
If SW (2) moves to switch on, measure the current of the Bluetooth
By switching on both, users can measure all current consumed by Bluetooth
6.5.2.1 DA16200/DA16600 EVK PRO Board (504-02-A)
The actual component locations of the DA16200/DA16600 EVK PRO Board are shown in
User Manual
CFR0012

Figure 50: Setup DA16200 EVB Jumper

Figure 52: Setup DA16600 EVB Jumper

Revision 1.8
66 of 106
Figure 52.
®
LE chipset
®
LE and Wi-Fi.
Figure
Aug. 18, 2023
© 2023 Renesas Electronics
53.