Roll Media Option Specifications - Oce Arizona 365 GT User Manual

Roll Media Option Specifications

Roll Media Option Specifications
Introduction
The Roll Media Option available for the Océ Arizona 365 GTprinters allows the use of various
flexible media that are supplied on a roll. Specifications associated with the use of roll media are
indicated in this section.
NOTE
The Océ Arizona 365 GT and the Roll Media Option must be operated in accordance with the
environmental conditions specified in the Océ Arizona 365 GT Site Preparation Guide and all
safety requirements noted in this document.
Media Size Supported
Width (Max.): 2.2m (86.6")
Width (Min.): 0.9m (36")
Roll Diameter (Max.): 240mm (9.45")
Core Inner Diameter: 76.2mm (3")
Print Size Supported
2.190m (86.2")
This allows for a minimum 5mm (0.2") border. This is necessary to ensure the platen is not
contaminated with ink due to possible media tracking errors. Cured and uncured ink on the platen
will have a serious effect on printer performance. Any spilled ink must be removed immediately
(See RMO Maintenance section). If an image exceeds the 5mm border requirement, printing will
not be allowed to proceed.
Maximum Media Thickness
This value is not officially specified. It is theoretically possible for the RMO system to
accommodate media up to 3mm (0.11 inches). However, most media at or near that thickness will
have problems in the transport mechanism of the RMO unit.
Maximum Supported Weight
Media Width (mm)
900 ≤ x < 1220
1220 ≤ x < 1480
1480 ≤ x < 1780
1780 ≤ x ≤ 2200
Leader & End of Roll Waste
Leader Waste: 560mm (22 inches)
Leader waste is the amount of media that cannot be printed between the roll media platen and
the take-up media roll. This waste is produced every time media is loaded, taped to the take-up
core and initialized in preparation for the first print. Trailer waste is the media that cannot be
80 Chapter 6 - How to Operate the Roll Media Option
Max. Weight kg (lbs)
28 (62)
40 (88)
45 (100)
50 (110)