Oce Arizona 365 GT User Manual page 192

How to Remove Ink from the Table
How to Clean Ink from the Maintenance Tray
During regular daily printhead maintenance, observe the grid on the top of the maintenance
station when the drawer is open. If you see any accumulation of ink, clean as follows:
1. Slide the door out from under the carriage to reveal the maintenance station.
2. Wipe up the majority of the ink by blotting with an absorbent cloth.
3. Pour some alcohol on a lint-free cloth and wipe away any ink deposits.
4. On a new cloth, apply some alcohol and remove any residual flush or other debris.
NOTE
If you leave the maintenance door open and do not wipe away any deposited ink, it will
gradually cure from exposure to light and thus become very difficult to remove.
How to Unplug Vacuum Holes
1. Identify any vacuum holes that are plugged with ink.
2. With an 1.5mm diameter rigid material (e.g., a paper clip), ream out any of the holes that
have been plugged.
3. Clear any resulting debris with a vacuum cleaner or a wet lint-free cloth.
192 Chapter 11 - Printer Maintenance