Oce Arizona 365 GT User Manual page 93

5. Tape the pointed end of the media to the take-up core as shown below.
[52] Tape media to core
6. Remove the tape you used to hold the media to the platen.
7. Select the "Initialize" icon from the Roll Media Manager to prepare the RMO for printing.
8. After initialization has completed, advance the media until the cut area is wound onto the core
across the width of the roll and verify with the ruler that the supply and take-up edges are at the
same location.
NOTE
Important: Use the supplied ruler to check that the edge of the take-up roll is aligned within
1mm of the feed roll.
9. Start an RMO print job and verify image quality and that there are no wrinkles or banding.
Loading the Media - Alternate Method
Chapter 6 - How to Operate the Roll Media Option 93