Oce Arizona 365 GT User Manual page 102

How to Print on Roll Media
NOTE
If the media width entered is less than 1067 mm (3.5 ft) the standard nozzle check will not
fit across the media. In this case, if the Nozzle Check icon is selected from the Print Job
Control command toolbar, the narrow version of the nozzle check (Nozzle Check Narrow) is
automatically added to the print queue.
Nozzle Check print: 1067 x 107.5 (3.5 x 0.35 ft)
Nozzle Check Narrow: 886.5 x 214.7 (2.9 x 0.70 ft)
5. Check that the rest of the media parameters displayed match the particular media you loaded.
6. You can create a new media or edit an existing one by changing the parameter values and then
saving them under a new media name. When you create a new media it takes the current values
as default and automatically creates a unique media name based on the existing name.
NOTE
Any changed parameter in the dialog window will be applied to the next roll media
print job, even if the change was not saved. This allows temporary changes to the
parameters without the need to save that media.
[57] Roll Media Manager Keyboard
NOTE
There is always at least one media in the list that is called Default Media. It cannot be
deleted, but you can change its parameters if you want to use it. If you choose to delete it,
the parameters will go back to its original values, but the item will still appear in the list.
7. Select the Media Tension
8. Select the Media Advance Correction Factor
NOTE
Leave it at 50 unless you see light or dark lines of banding in the printed image (refer to
the next section "How to Set the Media Advance Correction Factor for more details).
9. When the displayed media values are correctly matched to the loaded media, click Close to exit
the Media Manager.
10. Click on the Roll icon in the menu bar of the Job Control module to activate the RMO print queue
(the icon will change from yellow to green).
102 Chapter 6 - How to Operate the Roll Media Option