Oce Arizona 365 GT User Manual page 188

Swab Printheads
6. Rotate the swab by 180 degrees and repeat the previous step.
7. Discard the swab and repeat Steps 2 to 5 for all the other printheads (if needed).
8. Perform Printhead Maintenance again.
9. Once finished, all residual flush or alcohol and ink in the gaps around the head must be carefully
wiped away with a clean swab.
10. Run a Nozzle Check print or an image test print and verify that all nozzles are firing properly.
NOTE
If the problem persists, you can swab multiple times. Use a new clean side of the swab
each time (this means a maximum of two swipes per swab). It is possible that as many as
ten swipes can be required. If swabbing does not recover a blocked nozzle, holding a flush-
soaked swab against the blocked nozzle on the printhead for at least ten seconds is an
effective way of clearing the blockage.
11. Run another nozzle check, if necessary. When the Nozzle Check print does not show any nozzles
out, the printer is ready to produce quality images.
188 Chapter 11 - Printer Maintenance