Oce Arizona 365 GT User Manual page 208

How to Change a UV Lamp Bulb
2. Disconnect the UV lamp housing power cable connector by pressing in the two blue tabs on
either side and pull it out.
[150] Disconnect power cable
3. Remove the foam filter from the top of the housing by lifting the exposed edge as shown below.
It is flexible and will bend as you remove it.
[151] Remove Lamp Filter
4. Swing the UV lamp housing interlock safety arm out of the way:
[152] Interlock Safety Arm
• first lift it straight up to the height of the blue connector;
• then angle it away from the connector as you raise it higher; and
• finally swing the arm back over the connector and past the raised part of the lamp housing.
NOTE
The UV lamp housing cannot be removed from the carriage until the bracket is swung
out of the way.
5. Lift the UV lamp housing straight up and out of its carriage bucket.
208 Chapter 11 - Printer Maintenance