Oce Arizona 365 GT User Manual page 46

Print Job Control Module
4 & 5) Command Toolbar
The printer toolbar contains buttons that allow you to interact with the printer (listed in the table
below in the order they are displayed on the command toolbar). Note that some of the buttons
have a checked and unchecked state with a different appearance of the icon image to reflect their
state.
[24] Command Toolbar
Print job
Hold job
Cancel job
Delete job
Flatbed icon
46 Chapter 4 - How to Navigate the User Interface
This command can do the following actions depending on context:
• Activates a selected inactive job by moving it to the active list.
• Un-holds a held job.
• Un-holds an job that had an error currently.
The command can do following actions depending on context:
• Puts an active job on hold.
• Waits until the printer finishes a currently printing copy and puts the job
on hold.
The command can do following actions depending on context:
• Deactivates a selected active job by moving it to the inactive list. Note
that Special Prints will not move to the inactive list.
• Cancels a currently printing job and moves it to the inactive list. Note
that the first click cancels the print, but the carriage will continue to ap-
ply curing passes so that the ink cures properly. A second click termi-
nates the print job immediately and gives a warning about uncured ink.
Deletes a job from the printer. However, you cannot delete a job that is cur-
rently printing.
Process flatbed jobs toggle command - Allows printer to process flatbed
jobs. This must be selected to enable flatbed printing when the printer is
booted or after re-setting the printer due to an error.
4