Oce Arizona 365 GT User Manual page 86

How to Load Media
you have a roll that is not even, before loading it, hold the roll in a vertical position and carefully
and evenly drop one end onto the floor, then tap lightly a few times. If any edges are crushed,
unwind and throw away the crushed area or cut off the crushed end of roll. If is not possible to
repair, do not use it.
NOTE
If media has been stored on its side and has a pronounced flat side, do not use it as it will not
advance evenly.
Required tools
5mm hex key
Load Supply Media Roll and Position a Take-up Shaft
Procedure
1. Place an empty media shaft on a suitable flat work area, positioned as shown, so that the 5mm
hex key is inserted on the right side of the shaft to lock and unlock the core locks.
[44] Unlock the Media Shaft Core Locks
2. To unlock the media shaft core locks (1) turn counter-clockwise with the supplied 5mm hex key
(2).
3. Slide a new roll of media onto the supply shaft.
4. Roughly center the roll on the shaft, and then insert the shaft into the Supply (bottom) position on
the printer. Insert one end of the shaft at a time.
NOTE
Load the shaft with the core lock and coupler end on the right side of the printer.
86 Chapter 6 - How to Operate the Roll Media Option