Oce Arizona 365 GT User Manual page 107

3. Bend the height adjustor (small triangle in the top corner of the edge protector) slightly and then
straighten it again. This results in a slight bend (no more than a media thickness), that allows the
media edge to move more freely under the protector.
[60] Media Edge Detector Height Adjustor
IMPORTANT
If the height adjustor area is higher than 1 mm from the platen, there is a possibility that
the carriage may hit the edge of the protector and thus damage printhead nozzles.
4. Peel the backing layer from the double-sided tape on the back of the protector.
5. Place the bent edge of the protector into the media cut guide, but do not press down on the tape
yet.
6. Slide the protector towards the media edge until the inside edge of the height adjustor is
positioned over the media edge (see figure below).
NOTE
Do not let the plastic edge near the arc butt up against the media edge or the device may
not let the media pass smoothly.
The vacuum in the platen will hold the main part of the protector in place while the image
is printed.
7. Press down on the tape to fasten the protector in this position.
[61] Edge Protector in Position
How to Use Media Edge Protectors
Chapter 6 - How to Operate the Roll Media Option 107