Oce Arizona 365 GT User Manual page 67

IMPORTANT
To maintain optimal printer reliability, leave the power on at all times. However, there are
exceptions such as for ink flushes, some service procedures, or if the printer requires a reboot. If
you need to shut down the printer for just a few minutes, follow this procedure. However, if you
need to leave the printer idle for periods of 30 minutes to 14 days, see the table below.
Procedure
1. Turn off the UV lamps.
2. Wait for the lamps to cool down (fans will stop).
3. Click on the Shutdown icon in the Tools and Utilities tab to exit the printer software.
4. Turn the AC power switch to the OFF position.
5. Turn the power back on when the service or procedure is complete.
NOTE
Avoid Extended Power Off
If the power is switched off for only a short period (for example, when the printer is
shut down and then immediately restarted to correct an electrical problem or other
troubleshooting), no special action is required at startup. However, if it is necessary to
leave the printer idle for an extended period refer to the table below. Also, perform
Automatic and Manual Maintenance when you start to use it again. We recommend
that you leave the printer powered On at all times except for service repair.
Chapter 5 - How to Operate Your Océ Arizona Printer
How to Power Off
67