Keysight Technologies FieldFox B Series User Manual page 763

System Settings
System Configuration
— Then
— Then
— Then Voltage x.xx V Using
—
—
—
Security Level
For security reasons, you can prevent frequency information from appearing on
the FieldFox while in SA, NA, or CAT modes.
How to set Security Level
— Press System 7
— Then
— Then
— Then choose from the following:
Keysight N9938-90006 User's Guide
Voltage Source.
Source ON OFF to enable and disable the voltage source output.
keypad, enter a value between 0.001 and 32 volts.
Clear Overload If the voltage source becomes 'TRIPPED' press to re-enable
the voltage source output. Then set
Status Line ON OFF Turn ON and OFF the voltage source status line that
appears near the top of the screen. The status line is always ON while
making Voltage Source settings.
Hi Impd. Load ON OFF
current use (Ramp). Default = OFF (Low current (Step)).
System Configuration
Security Level
— None All frequency settings are visible.
— High Frequency information is blanked from the following:
——Display annotation
——Softkeys
——Marker display and marker table
——Calibration properties
——All settings tables
——Limit line tables
——All saved.png files
— Any of the following will re-display frequency information:
——Set to None, Preset, Mode Preset, or FieldFox restart.
arrows, the rotary knob, or numeric
Source ON.
Enables/Disables low current use (Step) and high
763