Keysight Technologies FieldFox B Series User Manual page 728

System Settings
Audio (Volume) Control
How to set User Preset
— Make your custom settings for all modes.
— When finished, press Preset.
— Then
— Then
How to recall User Preset
— Press Preset.
— Then choose from the following:
—
—
—
Audio (Volume) Control
System volume control is a FieldFox global setting which sets speaker volume
for ALL success beeps, key press clicks, and individual features that use the
FieldFox speaker, such as SA Mode Tune and Listen.
The volume control setting remains through a FieldFox Preset. To cause your
volume control setting to remain through a FieldFox shut down, save the
setting as a Preference. Learn how in
page
728
Save User Preset,
User Preset ON
— Preset (User) The entire UserPreset.sta file is recalled. ALL modes
assume the settings that were in place when the User Preset was
saved. The active mode is the mode that was visible when the file was
saved.
— Mode Preset (User)
recalled from UserPreset.sta.
Only the instrument settings are saved to UserPreset.sta. No trace data
or calibration data is saved.
User Preset ON / OFF is saved as a Preference setting. Like all
preferences, this setting survives a FieldFox shut down and power ON.
Therefore, when User Preset is ON during shut down, the FieldFox will
load UserPreset.sta when it is powered ON.
To return to Factory Preset, select
UserPreset.sta remain stored on the FieldFox. When User Preset is OFF,
you can also set the Startup Mode preference that determines which
mode will be visible after powering ON. Learn more in
on page 744.
.
742.
then select Yes to confirm.
The settings for only the current mode are
User Preset
"Save and Reset Preferences" on
Keysight N9938-90006 User's Guide
OFF. The contents of
"Startup Mode"