Keysight Technologies FieldFox B Series User Manual page 41

Preparing for Initial Use of Your New FieldFox
Take the FieldFox Tour
Top Panel
Caption Descriptions
Port 1 For CAT and NA measurements, use to make reflection measurements.
RF Output Maximum: ±50 VDC, +27 dBm RF
Also, for SA source output in SA mode.
Port 2 For SA, use to make all measurements.
SA RF Input
For CAT, NA, and VVM mode, use to make Port 2 transmission
measurements.
Maximum: ±50 VDC, +27 dBm RF.
GPS Ant SMA (f) connector for use with built-in GPS. Produces a settable 3.3 VDC or
5 VDC bias voltage for the antenna pre-amplifier. Use with a GPS antenna
such as N9910X-825. Other GPS antennas can also be used.
Ref In SMA (f) connector for use with Frequency Reference Source and External
Trig In Trigger Input signal.
Maximum: 5.5 VDC.
Keysight N9938-90006 User's Guide
Learn More:
"CAT Mode Settings"
on page 51
"NA Mode Settings" on
page 91
Chapter 9, "SA
(Spectrum Analyzer)
Mode (Option
233–Mixed Analyzers)",
on page 147
"SA Mode Settings" on
page 151
"GPS" on page 746
"Frequency Reference
Source" on page 760.
"Triggering" on
page 192
41