Keysight Technologies FieldFox B Series User Manual page 766

System Settings
System Configuration
Table 30-1 LAN LEDs
LAN LEDs
Yellow:
— Flash, pause = 10 Mbit link speed
— Flash, flash, pause = 100 Mbit link speed
— Flash, flash, flash, pause = 1 GBit link speed
How to configure LAN settings
The first three 'Current...' settings can NOT be edited.
— Press System 7.
— Then System Configuration.
— Then More.
— Then LAN.
— Use the
— Hostname Change the name that can be used to address the FieldFox if
— Obtain IP Choose from:
For all FieldFoxes with firmware ≤A.08.18 and ≤A.09.50 FW, when using
Static IP addresses:
— Static Subnet Mask - Enter the Subnet Mask – including periods - in the
— Static Gateway - Enter the Static Gateway – including periods - in the
— Static DNS - Enter the Static DNS – including periods - in the format
766
arrows to select one of the following, then press Edit.
your server supports this feature. The default hostname is generated
automatically.
— DHCP - IP Address is assigned dynamically. If your server supports
this feature, the IP Address for the FieldFox is assigned each time it is
started.
— Static - Set the IP Address manually. The Address remains until you
change it.
— Static IP Address - Enter the IP Address – including periods - in the
format nnn.nnn.nnn.nnn
— Either a valid Static Gateway is required or 0.0.0.0.
— Either a valid Static DNS is required or 0.0.0.0. (If entry is available.)
format nnn.nnn.nnn.nnn
format nnn.nnn.nnn.nnn
nnn.nnn.nnn.nnn
Keysight N9938-90006 User's Guide