Keysight Technologies FieldFox B Series User Manual page 440

5G Rapid Prototype Phased Array Antenna – Option 360
How to Use Data Logging/Playback (Option 360)
How to Record a Data Log
Data Log-Play files are saved to:
—
—
— Press Trace 6
— Then
— Then
During recording, choose from the following:
—
—
To change Data Logging Configuration settings:
— Press Trace 6
— Then
— Then
440
If File Folder is set to Default then Data Log-Play files are save-recalled
to:
"[CurrentDevice]\RecordPlayback\PAA"
If File Folders are set to System, then Data Log-Play files are
save-recalled to:
"CurrentDevice\<UserSelectedFolder>\
Data Logging
Record
is displayed in the left of screen graticules.
Pause Resume Temporarily halts recording until pressed again. The
incoming trace continues to sweep. Press again to continue recording.
Stop Immediately stops recording. Then choose from the following:
— Then Record Save/Recall
your file settings. Learn more, refer to
Configuration settings:" on page
——Press Save Log File
save device is Internal).
— Then Record Settings
measurement interval settings. Learn more, refer to
Logging Configuration settings:" on page
Data Logging then choose:
Record Settings
— Optional: Then Meas Interval
——Then Interval Type
——Then, if applicable
Or
——Then, if applicable
miters.
To save a log file, recall log file, or change
"To change Data Logging
440.
to save the current Table data (i.e., default
(Outdoor Logging) To change your
(Outdoor Mapping Only)
> ON
> choose Time or Distance.
Time Interval
Distance Interval
Keysight N9938-90006 User's Guide
"To change Data
440.
enter time interval in seconds.
enter distance interval in