Keysight Technologies FieldFox B Series User Manual page 623

Channel Scanner (Option 312)
How to Set Up Channel Scanner
How to Set Up Channel Scanner
This section briefly reviews the steps in setting up a channel scan
measurement. If you are not familiar with this process or would like more
information, refer to
1. Define some channels (refer to
2. Select
3. Modify scale and specify color bar coding—Modify the scale and assign
4. Enable Data Logging Settings: Press Measure 1 or Trace 6 >
Keysight N9938-90006 User's Guide
"How to Define a Channel and Use Channel
Scanner").
a. Select a Scan Mode—choose:
— Range Specify total channels, channel spacing or
— Custom List
b. Then modify channels based on the selected scan mode
Display Type—choose:
— Bar ChartV or
— Bar ChartH or
— Channel Pow or
— Strip Chart or
— Then More and
— Chart Overlay
— Scan&Listen
colors to low and high power channels (bars):
Press Scale/Amptd
Then one of the following:
— Red Limit to set the power level and color scale for high power
channels.
— Blue Limit to set the power level and color scale for low power
channels.
— Others: Scale, Ref
to view the Data Logging softkeys and set the
Save/Recall, and More
— Record (Outdoor Logging) or
— Play (If you have previously stored data recordings.) or
— View
a. To set the Record Settings
"How to Define a Channel and Use Channel
Specify a list of channels from an editor
or
Level, RF Atten, etcetera as desired.
> Indoor Map Data Logging
(Outdoor Mapping only)—choose:
Scanner".
Data Logging
Record Settings, Record
or Signal Locate.
623