Independent Source/Tracking Generator - Keysight Technologies FieldFox B Series User Manual

SA (Spectrum Analyzer) Mode (Option 233–Mixed Analyzers)
SA Mode Settings

Independent Source/Tracking Generator

For best results, when using the independent source feature, InstAlign and
the battery saver features should be turned off. Refer to
Individual Alignments" on page 205
This feature may require an option. For a comprehensive list, view the FieldFox
Configuration Guide at:
https://www.keysight.com/us/en/assets/7018-06515/configuration-guides/
5992-3701.pdf
A tracking generator, a popular option with Spectrum Analyzers, is a source
which always tracks the SA receiver.
Like a traditional tracking generator, the Independent Source feature can set
the internal FieldFox source to track the SA receiver frequency range. It can
also set the internal source to a CW frequency that is independent of the SA
frequency.
Independent Source can be enabled ONLY when the FieldFox is in SA mode.
To view the internal source, you must connect a cable or device between the
RF Output connector and the RF Input connector.
How to make Independent Source Settings
— Press Measure 1 >
—
—
—
Keysight N9938-90006 User's Guide
Source
Source Enable ON OFF
— ON Turns ON the internal source.
— OFF Turns OFF the internal source.
Source Mode Choose from the following:
— Tracking The internal source frequency can track the SA receiver.
Center frequency
— CW The source is set to a CW frequency independent from the SA
settings. Srcw is annotated on the screen.
— Coupled CW The source is set to a CW frequency, but that frequency
"tracks" the SA receiver Center Frequency settings. Therefore, the
signal always appears at center of the display.
the screen.
Normalize ON OFF With Source Enable ON and Source Mode = Tracking,
Normalize ON stores the current measurement trace into Trace 4 in View
state as a reference trace. All subsequent trace measurements subtract
this Trace 4 reference trace, and therefore become relative to it.
and "Preferences" on page
Src is annotated on the screen
"How to Access
740.
Srcp is annotated on
SrcN is
181