Keysight Technologies FieldFox B Series User Manual page 433

5G Rapid Prototype Phased Array Antenna – Option 360
How to Set Up Phased Array Antenna Settings
2. Press
Step 6: Enable Data Logging and Playback the Results
Spectrum and Strip Chart information is not recorded. Only the Table and
Bar Chart data are saved. See
Data Logging creates a record of your data with a timestamp and GPS stamp
(refer to
log results to include a GPS stamp or use Preferences to enable the timestamp.
Refer to
Features
— Log files contain cell results for different component carriers (CCs)
— Data results can be logged
— Data results can be saved to a *.CSV, DREC (Option 360 only), or *.KML file.
— User specifies how often results are stored.
Procedure
1. Press
Keysight N9938-90006 User's Guide
— Storage Device
Scale/Amptd then choose:
— Autoscale
— Unit dBm
— External Gain
— External Gain
"GNSS (GPS+) and GPS" on page
Chapter 30, "System Settings."
including timestamps and/or distance stamps.
— Timestamps are included in log files with or without GPS.
— GPS must be enabled for log altitude results.
See also "GNSS (GPS+) and GPS" on page
Refer to "" on page 437.
— Time: Store results every "n" seconds
— Altitude: Store results every "n" meters. GPS must be enabled to
store results by altitude.
Trace 6 > Data Logging
the Record Settings, Record
— Record (Outdoor Logging) or
— Play (If you have previously stored data recordings.)
a. Outdoor Mapping only: To set the
"How to Record a Data Log" on page
756). GPS must be enabled for the
756.
to view the Data Logging softkeys and set
Save/Recall, and Indoor Map Data
Record Settings—choose:
440.
Logging.
433