Keysight Technologies FieldFox B Series User Manual page 391

Over–the–Air Measurements (OTA) – LTE FDD Option 370, LTE TDD Option 371, 5G TF
Option 377, 5G NR / 5G NR EVM Conducted Option 378
How to Set Up EMF Mode Settings (Requires EMF (Option 358) and 5G NR (Option
378))
If the antenna factor import is successful, the FieldFox displays:
"Success: Antenna Factors Imported: Tri-Ax Antenna ID:
->[R] Antenna ID: SDIA-6000-1006 ->[]". The last 4-digits will vary
for each antenna (i.e., "1006" is changeable).
If the FieldFox displays this error Error: USB antenna Error: Not
found or Unable to communicate with antenna. Ensure it is
connected. is displayed, verify the USB antenna is connected correctly.
Refer to
4. Modifying the EMF settings:
5. Once you have finished with your USB antenna setup:
Keysight N9938-90006 User's Guide
— Press Import Antenna
antenna's memory over the USB connection (this may take 5
seconds or so and vary with the Triaxial antenna).
"Troubleshooting" on page
— Press USB Antenna
— Then USB Antenna [Tri Axial]
selected.
— Optional: Press
set to Auto for default operation. When AUTO is selected
the application (e.g., Channel Power or OTA) controls the
axes and switches themas needed. With the AUTO setting,
all antenna elements (X, Y, and Z) are OFF.
— Press Back
Press Meas Setup 4
— Then More > EMF
— EMF Meas OFF ON
— EMF Units
— Back
For more details on editing the USB antenna, refer to
Antennas – (Full Capability Requires EMF Option 358, and either SA mode
(Option 233 Mixed Analyzers) or OTA—5G NR / 5G NR EVM Conducted
Option 378)."
a. Press Sweep 3 >
The FieldFox should display in order Analyzing CCO X-Axis,
Analyzing CCO Y-Axis, and Analyzing CCO X-Axis and then
do a square root sum of the X, Y, and Z measurement values in the
FieldFox. Multi-cell measurements are done similarly for each cell
ID (i.e., Cell CC0 to CCn). Refer to
b. Verify OTA 5G NR X, Y, and Z Axes Factors in SA Mode (e.g., 3.5 GHz
signal)). Refer to
to import the antenna factors from the
399.
then:
Antenna Axis
> Back to exit the USB Antenna softkey menu.
then
disable/enable the EMF measurement.
choose dBuV/m (default) or V/m.
to exit to the previous softkey menu.
Single > Restart
Figure 13-27 on page
Figure 13-28 on page
verify Tri Axial (default) is
the antenna axis should be
Chapter 15, "USB
392.
393.
391