Keysight Technologies FieldFox B Series User Manual page 474

Indoor and Outdoor Mapping – Option 352 (Requires Spectrum Analyzer Mode (Option
233), and GPS Receiver (Option 307))
How to Set Up Mapping Settings
Option 352 Indoor Maps Setup Procedure
IMPORTANT!
85571A-028 (28 GHz 5G Phased Array Antenna) accessories not suitable
for use in wet locations.
1. Set up your measurements in Channel Scanner, OTA, or Phased Array
2. Plan your Indoor Map:
Import your floor plan, before the locations are going to be measured.
474
Antenna. See also, Chapter 13, "Over–the–Air Measurements (OTA) – LTE
FDD Option 370, LTE TDD Option 371, 5G TF Option 377, 5G NR / 5G NR
EVM Conducted Option 378,"
312)."
One or more are required:
— For setting up a phased array antenna, refer to
Rapid Prototype Phased Array Antenna – Option 360."
— For setting up a USB antenna, refer to
(Full Capability Requires EMF Option 358, and either SA mode
(Option 233 Mixed Analyzers) or OTA—5G NR / 5G NR EVM
Conducted Option 378)."
Optional:
— For setting up GPS Option 307, refer to
Settings," and then
a. Save mapping pictures to the FieldFox using USB storage device, SD
card, or connect to LAN with internet and download.
b. Import floor plans or site maps to the FieldFox from pictures (PNG,
JPG, and BMP).
Press System 7 >
Import Maps > Import Maps (ZIP)
Optional:
— Press Source Device [Internal]
USB, or CD Drive
— Press Destination Device [Internal]
Card, USB, or
c. Recommended: Do an interactive Walk Test data collection using
the location pointer.
and Chapter 27, "Channel Scanner (Option
Chapter 15, "USB Antennas –
Chapter 30, "System
"GNSS (GPS+) and GPS" on page
Utilities > Mapping >
– Internal
CD Drive
Keysight N9938-90006 User's Guide
Chapter 14, "5G
756.
Map Explorer (Get Maps)
(default), SD Card,
– Internal (default),
>
SD