Keysight Technologies FieldFox B Series User Manual page 422

5G Rapid Prototype Phased Array Antenna – Option 360
How to Set Up Phased Array Antenna Settings
If after making the setting changes in the steps below, no data is
displayed, refer to
7. User markers to identify azimuth and elevations settings:
8. Enable the Data Logging settings:
422
— Clear Graphics
graphic from the screen.
"Troubleshooting" on page
Select Marker –choose:
— Marker 1 2 3 4 5 6
Delta, or Peak softkey is black to indicate the current setting of each
marker.
— Normal displays a marker.
— Delta displays a marker relative to another active marker.
— Peak displays a marker on the peak point of the displayed trace.
— More – choose.
— Marker Trace – You can set up to four traces.
— Marker Table – Enable or disable the marker table that displays the
current markers and their values.
Learn more about markers. Refer to the
Features.".
See also Figure 14-5 on page
— Press Trace 6 >
— Record
— Play (If you have previously stored data recordings.) or
— To set Data Logging—choose:
a. Record Settings
If applicable, this clears the current displayed PNG
– You can set up to six markers. The OFF, Normal,
Chapter 29, "Data Analysis
412.
Data Logging then
(Outdoor Logging) or
(Outdoor Mapping only) – then choose:
— Optional: Then Meas Interval
— Then Interval Type
— Then, if applicable
interval in seconds.
Or
— Then, if applicable
distance interval in miters.
— Then Back
Keysight N9938-90006 User's Guide
443.
> ON
> choose Time or Distance.
Time Interval enter time
Distance Interval enter