Keysight Technologies FieldFox B Series User Manual page 421

5G Rapid Prototype Phased Array Antenna – Option 360
How to Set Up Phased Array Antenna Settings
5. Entering the phased array antenna measurement type:
6. Using the table to enter phased array antenna settings, presetting the
Keysight N9938-90006 User's Guide
Refer to "Data Formats:" on page
Select Measure:
— Measure—choose:
— Bore-Sight
— Heat Map
— Polar ANT
— Park ANT
antenna, setting the antenna LAN IP, and clearing the graphics:
Refer to Figure 14-16 on page
Select Meas Setup:
— Antenna Settings—choose:
— Ball Antenna > LAN Address
— Settings–choose:
— Array Antenna–choose:
— Polar Display >Ref
— Sweep > Dwell Time (Optional. For pulsed RF
measurements it is recommended that the Dwell Time is
increased.)
— Sweep > Max Hold (Optional. For pulsed RF
measurements it is recommended that Max Hold is set to
OFF when using the Heat Map display. (Default = OFF).)
— Preset Antenna
— Ant LAN IP enter the Ball antenna's LAN IP. First three fields must
match the FieldFox's static IP address (default: 192.168.1.10). Refer
to Figure 14-15 on page
408.
or
or
or
428.
——Res BW or
——Video BW
——Beam Width
——Center
——Azimuth Ref
——Elevation Ref
presets the antenna settings factory defaults.
427.
421