Advertisement
Indoor and Outdoor Mapping – Option 352 (Requires Spectrum Analyzer Mode (Option
233), and GPS Receiver (Option 307))
How to Set Up Mapping Settings
488
— To change your file settings or measurement interval.
Learn more, refer to
Configuration settings:" on page
— Press
Maps
– to open a softkey menu enable map view and related
features (e.g., Data Selection, Red/Blue Limits, Labels & Icons,
Zoom).
Then choose from the following:
——View Map OFF ON
——Data Selection
——Red/Blue Limits
——Zoom
——Labels & Icons
"To change Data Logging
To enable/disable the current
map view (default = latitude/longitude = 0.00/00.
Need GPS to view current location (default =
OFF).
Opens a softkey menu to set the
active data channel, sort type, and sort order.
Then Choose:
Sets the data channel being recorded.
Channel 1
Available channels will vary within each
mode.
Sets the type of measurement displayed
Sort
(Power or Frequency).
Power Freq
Sets the sort order to ascending (Up)
Sort Order
greater power/frequencies displayed first
Up Down
or descending (Down) lowest power or
frequency values displayed first.
Returns to previous softkey menu.
Back
Opens a softkey menu to assign
power values to the red (high power limits) and
blue (low power limits) heat map display limits
(defaults: Red Limit = –20 dBm, Blue limit = –90
dBm).
Zoom in/out on the map displayed.
Opens a softkey menu to
enable/disable map data point labels and icon
types.
Then choose from the following:
Enables/Disables map data point labels.
Labels
When enabled, a label is displayed for every
OFF ON
map data point (e.g., "Data 1"). When
disabled, labels are not displayed for the
map data points.
Keysight N9938-90006 User's Guide
500.
Advertisement
Chapters
