Keysight Technologies FieldFox B Series User Manual page 236

SA (Spectrum Analyzer) Mode (Option 233–Mixed Analyzers)
How to Set Up EMF Settings (Requires EMF (Option 358), GPS (Option 307), and SA
Mode (Option 233–Mixed Analyzers))
236
a. Then press Cable Off
Frequency and Cable Loss table values that are stored in the
FieldFox [:Internal]:\Cable\ directory (Refer to
Then you can edit the following:
— Description – edits the name of the current cable correction
settings table
— Frequency Interpolation – sets the frequency interpolation to
linear or to log.
— Frequency – edits the frequency value measured that
corresponds to a particular Cable Loss.
— Cable Loss – edits the Cable Loss value that corresponds to a
particular frequency.
Refer to next step for details on editing the cable Settings
table.
b. Use the arrows, the rotary knob, or numeric keypad to select
the table cell value to be edited (i.e., the Frequency Interpolation
value is not editable). Then:
— Press Edit Cable
press New to add a a new antenna's factors or to write over
your existing antenna's file (i.e.,
data? is displayed above the table).
— Choose
— Choose
filename is Example).
— Press Add Row
values.
— Press Delete/Clear
— Delete Row
currently selected row of Frequency and Cable Loss
(i.e., you must press
the current softkey menu).
— Clear All
the currently selected rows of Frequency and Cable
Loss (i.e., you must press
No
— Back
— Press Done when finished editing to exit.
> Edit Cable to edit the existing cable's
to edit your existing cable loss data or
Overwrite existing Cable
Yes to write over the existing cable file.
No to create a new cable file (default
to create additional Frequency and Cable Loss
then choose one of these:
– when pressed this choice deletes the
Yes to delete a row or
– when pressed this choice deletes all of
to exit the current softkey menu).
– To exit to previous softkey menu.
Keysight N9938-90006 User's Guide
Figure 9-22).
No to exit
Yes to deleted the rows or