Keysight Technologies FieldFox B Series User Manual page 727

System Settings
Preset
Preset
The Preset key restores the FieldFox measurement settings to a known
condition. You can preset the entire instrument, or just the current Mode (CAT,
SA, and so forth).
When Preset, the FieldFox CalReady calibration is recalled for use in CAT and
NA Modes. Learn more in
In addition to all Preference settings, the following settings always survive
Preset and Mode Preset:
— External Reference state (see
— SA Scale and Units (see
— SA Correction states (see
— VVM Display Resolution (see
— Marker Peak Excursion and Threshold (see
How to Preset the FieldFox
— Press Preset.
— Then choose one of the following:
User Preset
User Preset allows you to store custom settings for each mode, then recall the
settings when the Preset key is pressed. Your custom settings are saved to a
standard State file (UserPreset.sta). However, unlike State files, calibration
data is NOT saved. Learn more ab0out State files in
Device" on page
Keysight N9938-90006 User's Guide
— Single Automatically sets Continuous OFF (Hold) and causes
FieldFox to make ONE measurement sweep, then hold for the next
Single key press.
— SA Mode ONLY – With
press also causes a single sweep.
— Continuous ON OFF
setting when battery power is not critical.
— Preset Returns ALL Modes to the factory default settings.
— Mode Preset Returns only the current Mode to the factory default
settings. The current settings for all other Modes remain.
783.
Continuous OFF
Makes continuous sweeps. This is the typical
"CalReady" on page 127.
"Frequency Reference Source" on page
"Scale and Units" on page
"Field Strength Measurements" on page
"Display Resolution" on page
"What Is a 'Peak'" on page
each successive Run/Hold
157)
161)
588)
"Set File Type and Select
760)
711)
727