Keysight Technologies FieldFox B Series User Manual page 452

USB Antennas – (Full Capability Requires EMF Option 358, and either SA mode (Option
233 Mixed Analyzers) or OTA—5G NR / 5G NR EVM Conducted Option 378)
How to Set Up a USB Antenna
If the antenna factor import is successful, the FieldFox displays:
"Success: Antenna Factors Imported: Tri-Ax Antenna ID:
->[R] Antenna ID: SDIA-6000-1006 ->[]". The last 4-digits will vary
for each antenna (i.e., "1006" is changeable).
If the FieldFox displays this error Error: USB antenna Error: Not
found or Unable to communicate with antenna. Ensure it is
connected. is displayed, verify the USB antenna is connected correctly.
Refer to
4. If you have not selected a mode and set up your measurement, then do so
5. Enabling the imported USB antenna factors and Cable factors:
6. If you need to edit or add new antenna factors or cable factors, then
7. Once you have finished with your USB antenna setup:
452
— Then Import Antenna
antenna connected to the FieldFox.
"Troubleshooting" on page
— Then USB Antenna [Tri Axial]
Only compatible USB triaxial antennas can be used for EMF
measurements.
— Optional: Press
FieldFox determines the X/Y/Z settings for the current
measurement. Alternately, you can select either X, Y, or Z to enable
and to edit a position manually (i.e., an example of editing X, Y, and
Z axes is covered in step 5).
now. Refer to step 1.
Choose one of these:
— SA Mode: "How to Set Up EMF Settings (Requires EMF (Option 358),
GPS (Option 307), and SA Mode (Option 233–Mixed Analyzers))" on
page 226
— OTA Mode: "How to Set Up EMF Mode Settings (Requires EMF
(Option 358) and 5G NR (Option 378))" on page 387
repeat step 5 as required for Y, Z, and the Cable Factors. See also,
Set Up EMF Settings (Requires EMF (Option 358), GPS (Option 307), and
SA Mode (Option 233–Mixed Analyzers))" on page 226
EMF Mode Settings (Requires EMF (Option 358) and 5G NR (Option 378))"
on page 387.
a. Press Sweep 3 >
– to import the antenna factors from the USB
456.
verify Tri Axial (default) is selected.
Antenna Axis with Auto (default) selected the
Single > Restart
Keysight N9938-90006 User's Guide
"How to
and "How to Set Up