Keysight Technologies FieldFox B Series User Manual page 487

Indoor and Outdoor Mapping – Option 352 (Requires Spectrum Analyzer Mode (Option
233), and GPS Receiver (Option 307))
How to Set Up Mapping Settings
Setting up Outdoor Mapping
1. Press
2. Press
3. Then choose from the following:
Keysight N9938-90006 User's Guide
This softkey is only available in Channel Scanner and Phased Array
Antenna modes (i.e., The Cursor Position softkey is not available for
OTA mode).
— Red Limit to edit the red maximum power limit dBm value.
— Blue Limit to edit the blue minimum power limit dBm value.
Record Settings
— Meas Interval OFF ON
softkeys active (default = OFF).
— Interval Type choose Time or Distance.
— Time Interval Enter time in seconds (1s to 3.6 ks) or
— Distance Interval
Record Save/Recall
logging filenames and file folder locations
— Save Log File or
— Recall Log File (if you have previously stored data)
— File Folder Default System
— File Type (Default = CSV) KML or DREC (DREC applies to Option 360
only)
— Auto Save OFF ON
if power is lost (Default = OFF)
— Then Back
— Press Record to begin a new data log recording.
— Press Pause Resume
Temporarily halts recording until pressed again. The incoming trace
continues to sweep. Press again to continue recording.
— Press Play If this softkey is active, you are doing a new recording or
you have recalled a previously stored data logging file.
— Press Stop Immediately
— The Save the log file menu opens. Edit the filename and
press Done to exit menu. See Settings below and
change Data Logging Configuration settings:" on
page 500.
— then choose:
Enable to make the measurement interval
Enter time in miters (10m to 10 km)
Opens a softkey menu to manage your data
(Default = Default) or
To enable/disable auto save to protect your data,
(only displayed after Record has been pressed)
"To
487