Keysight Technologies FieldFox B Series User Manual page 176

SA (Spectrum Analyzer) Mode (Option 233–Mixed Analyzers)
SA Mode Settings
— Press
— Then
176
— Volume 0 – to enable disable volume and to adjust the volume from
0 to 100 (default = 50).
— Load Audio File
— Cap Auto–Load File
captured audio (.wav) file (default = OFF).
Capture Settings
— Capture Count – sets the number of audio captures for a
measurement (Default = 1; Settable: 1 to 10K).
— Capture Time – sets the capture time (Default = 100 ms).
Minimum/Maximum capture times vary with other settings.
— Stereo Channel
softkey sets the type of audio to be captured and stored: (Choose
single channel: Mono
Or choose two channel:
Then Choose:
Mono (L+R)
Stereo (L&R)
Left (L)
Right (R)
Difference (L–R)
File Settings then
— Filename – Opens the filename labeler to specify a filename.
— Timestamp OFF ON
audio (.wav) filename.
— Storage Device
(.wav) file. Select
For more on file settings refer to
– to load a previously stored audio (.wave) file.
– enable/disables automatically loading of a
then
– When Demod Type = FM Stereo / RDS, this
(L+R), Left (L), Right
Stereo (L&R). Default = Mono (L+R).
Sets the audio recording to Mono (single channel) and
combining left and right speaker sounds. This is the
default.
Sets the audio recorded to be stereo (two channels).
Sets the audio to be recorded to be the left speaker only.
Sets the audio to be recorded to be the right speaker
only.
Sets the audio to be recorded to be the value of the left
side minus the right side of the audio data (single
channel).
– Enables/disables a timestamp label on your
– Sets the storage device location for your audio
Internal (default), SD
Chapter 32, "File Management."
Keysight N9938-90006 User's Guide
(R), and Difference
Card, or USB.
(L–R).