Two-Wire SCSI Configuration (Default)
Quantum|ATL 7100 Series Facilities Planning and Installation Guide
This configuration connects the robotics controller, Drive 0, and
Drive 1 on one SCSI channel (interface). The second SCSI channel
is configured for drive 2 and drive 3 (see
The first channel from the host controller connects to the rear panel
connector labeled SCSI PORT 1 on the back of the unit and
externally terminates at the connection labeled SCSI PORT 2 . The
second SCSI channel from the host connects to the connector
labeled SCSI PORT 3 and externally terminates at the rear panel
connector labeled SCSI PORT 4 .
This is the default configuration of the library as shipped
Note:
from the factory. The external SCSI terminators are
provided in the accessories kit, but they are not shipped
installed on the rear panel.
Appendix A SCSI Cabling Options
Two-Wire SCSI Configuration (Default)
figure
13).
1
37