Connecting Viewstations To The Lan - Polycom ReadiManagerLX100 Management Manual

Appendix

Connecting ViewStations to the LAN

Make sure that a LAN cable connected from the local area network is connected to the orange connector on the back
of your ViewStation. See the ViewStation QuickStart booklet for details.
1. Turn on the ViewStation.
2. Press the right arrow button on the remote control to select the System Info icon. Then press the SELECT
3
4. Restart your ViewStation by turning it off then on again. Go to the System Information screen. You should see
Polycom ReadiManager LX100 User Guide
button to select it.
Press the right arrow button on the remote to go to the screens:
Setup > LAN/SNMP > LAN/Intranet >
If your LAN uses DHCP, press the up arrow on the remote to go to the DHCP field. Use the arrow button
to set the DHCP setting to Client. This enables the ViewStation to obtain an IP address from a server on
your network.
If your LAN does not use DHCP, set DHCP to off in the LAN/Intranet screen and manually enter the IP address,
subnet mask and gateway address provided by your system administrator.
your system's IP address. If the IP address displays "...waiting...", the ViewStation did not get an address from
a server on your LAN. Check the LAN connection and try again. The green light on the connector should be
illuminated and the yellow light should be blinking.
This ViewStation can now be added to the database.
Appendix 91