Polycom ReadiManagerLX100 Management Manual page 171

Appendix
iPower Admin Setup Menu
Admin Tools :: ISDN ::
IMUX Setup
iPower Field
IMUX type
IMUX Call Mode
Maximum call rate
IMUX Code setup
Polycom ReadiManager LX100 User Guide
IMUX Setup
Type Meaning
Pull Down menu None
The external network device does not use rate codes, or users
prefer to dial the code themselves.
DICA OASIS
The system is attached to a DICA OASIS IMUX. The system will
automatically generate rate codes for outgoing calls based on
this IMUX type.
Lucent Multiband
The system is attached to a Lucent Multiband IMUX. The
system will automatically generate rate codes for outgoing calls
based on this IMUX type.
Other
The system is attached to an IMUX that uses rate codes, but not
to one of the known types listed above. Please fill in the table
so the system can generate rate codes for outgoing calls.
Pull Down menu Dialed
This is the default mode. The system can place an outgoing call
by dialing a number. It can also receive incoming calls.
DCE Signaled
(non-dialed)
The network does not need a phone number to route a call.
Typically, the network is pre-configured to a specific destination.
V.35/RS-449 control leads signal the start and end of a call.
DCE Dedicated
(non-dialed)
The network provides a permanent connection. The V.35/RS-
449 control leads are constant and do not signal the start or
end of a call. Instead, the system uses framing patterns in the
transmitted and received data to signal the start and end of a
call.
Pull down menu Call rate supported by IMUX box.
Table Please refer to the iPower administrator user guide.
Appendix 164