Cdr Maintenance Configuration; Cdr Synchronization Configuration - Polycom ReadiManagerLX100 Management Manual

Server Preferences
CDR Maintenance Configuration
Report configuration enables the user to set the variables for storing CDR data.
Archive data older than - How often data is archived and written to disk. At this point, the data that is archived is
removed from the database and can only be viewed by using the archived files on disk.
Delete archives older than - The number of days archived data remains on disk before deletion. After these archives
are deleted, the data is no longer under the control of ReadiManager LX100.
Local time for archive maintenance - The time of day when archive maintenance occurs. The time should be a period
of the day when there is not expected to be much traffic through ReadiManager LX100.
The CDR data is stored to disk and can be found in the directory shown below on the server where ReadiManager
LX100 is installed. Note that the archived files are in .csv format.
drive:\program files\polycom\pwx\CDR\<device type>
CDR Synchronization Configuration
For ViewStations and V-Series that are not connected to Polycom ReadiManager LX100, CDR data is still being
collected by these endpoints. CDR Synchronization allows for the synching up of call data between the endpoint and
Polycom ReadiManager LX100. This feature prevents the loss of data when an endpoint is not connected to Polycom
ReadiManager LX100 because the ethernet cable has been disconnected from the endpoint but the endpoint is still
in an ISDN call. When the ethernet cable is reconnected with the endpoint, thus resulting in the reestablishing of
the Polycom ReadiManager LX100 - endpoint connection, Polycom ReadiManager LX100 will retrieve the call data
recorded by the endpoint when it was disconnected from the LAN during the synchronization period specified in
this page.
Enable CDR synchronization - Enables this feaure.
Synchronize every - The frequency at which Polycom ReadiManager LX100 is synchronizing call record data, the
default is 0 days. The maximum interval is every 21 days.
Local time for synchronization - The time of day that the server will be synchronizing call data.
Polycom ReadiManager LX100 User Guide Chapter 8 System Configuration 83