Polycom ReadiManagerLX100 Management Manual page 80

Call Detail Record
Interpreting the Report cont
Column header
Chan. cont.
BW
Min.
Cause
Disconnect
If failed calls were selected for the query, these calls will show up with 0 minutes for duration and 0 channels
connected.
Polycom ReadiManager LX100 User Guide
Description
NOTE
iPower systems show only 0 or 1 for the number of channels, regardless of the actual
number of ISDN channels used in an H.320 calls
Providers usually charge by how many lines connected, so in general, every 2 channels
connected equals 1 ISDN line. If the endpoint has ISDN bonding, then the number of channels
shown connected is what is shown. However, the number of lines connected is dependent on
how many channels were connected, i.e. (2 channels = 1 ISDN line, 3 channels = 2 ISDN lines)
If an odd number of channels connect, the number of ISDN lines connected is equal to the next
even number divided by 2, i.e., (5 channels= 6/2 = 3 ISDN lines).
When IP based calls are made, only 1 channel will be shown in this column.
Bit rate which call is made at. Not all video endpoints provide call bit rate.
Minutes. Duration of the cal
ISDN Cause Code. Cause Code. The V-Series and Polycom endpoints will report ISDN Cause
Codes, shown in this column.
NOTE
This field is only available if CDR synchronization is enabled.
Disconnect Reason
These are the disconnect reasons for the following error codes, applicable to the V-Series,
ViewStation models and FX and EX models. The reason text may be long and may be truncated
in the UI. The full text length will be visible when the report is exported into CSV.
NOTE
This field is only available if CDR synchronization is enabled.
Chapter 7 Reports 73